HP 98568A Installation Instruction page 218

HP 98726A Interface Card
3. Configure Your System
The graphics subsystem attached to this interface card can either be the
system console or a peripheral device. The following summary presents your
configuration options. The HP-UX operating system identifies the system
console using the following choices:
• CONSOLE CONFIGURATION
a. A Console Terminal is an RS- 232 terminal that has the remote bit
set on its interface card by either a switch being set or a resistor
being removed. Any Console Terminal connected to your system is
the system console, no matter what other terminals or displays are
connected to the system.
' >
b. As a second choice, any bit-mapped display attached to an interface
addressed to $560000 is the system console. This is the recommended
choice for the HP 98726A / HP 98730A subsystem used as a console.
c. For a third choice, the first bit-mapped display found in DIO-II space
is recognized as the console. The search is from lowest to highest
memory location in DIO-II space .
• PERIPHERAL CONFIGURATION
a. When a Console Terminal is the system console, the HP 98726A can be
placed at any legal location and is treated as a peripheral.
b. When a bit-mapped display is the system console at $560000, then the
HP 98726A must be placed at any legal address that is not $560000
and jumper JPl must be placed in the $800000 position. See previous
CA UTION note.
c. If a bit-mapped display is the system console and located in DIO-II
space, the HP 98726A must be addressed at a higher memory location
in DIO-II space. The jumper JPl setting is ignored in DIO-II space.
5-122 Adding Interface Cards