HP 98568A Installation Instruction page 449

HP 35723A HP Touch Bezel
7. Placing your thumbs under the lower corners of HP Touch, push up and
toward the monitor until HP Touch snaps firmly into place. Make sure
that the cable does not protrude from HP Touch. If it does protrude, pHIl
out the bottom edge of HP Touch, push the cable under and snap HP
Touch back into place (Figure 10-6).
Figure 10-6.
Attaching HP Touch
8. Find the HP-HIL cable that you purchased for the monitor. A separate
HP-HIL cable is required to connect the lllOnitor to your HP-HIL interface.
9. Find the end of the cable that is marked with one black dot.
10. Find the HP-HIL connector on the back of the monitor that is marked with
one dot (the inner-nlOst HP -HIL connector).
11. Plug the "one-dot" end of the cable into the ((one-dot" connector
011
the
moni tor.
12. COllnect the other, "two-dot" end of the cable into the HP-HIL connector
on your cOInpnter (marked "KYBD" or "KEYBOARD"), or to the
"two-dot" connector of the last HP-HIL device you installed (e.g.
keyboard).
1
;~.
Keep these constraints in mind:
Adding Miscellaneous Peripherals 10-7