Worksheet Entries - HP 98568A Installation Instruction

HP 91255/9127 A Flexible Disk Drives
Worksheet Entries
You have now installed your HP 9125S/27 A Flexible Disk Drive.
The following "Worksheet Entries" contain information needed to use your disk
drive with the HP-UX operating system. Refer to the entries for the interface
you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you will be ready to install your next peripheral. If you
have installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Table 6-24.
HP 91255/27 A Flexible Disk Drive
Connected to Built-in HP-IB Interface (Select Code 7)
Path
File
Major Minor
Interleave
Device Name
Name * Type Number Number **
Factor
HP 91258/27 A
/dev/dsk/#sO
b
0
Ox070nOO
2
HP 91258/27 A
/dev/rdsk/#sO
c 4 Ox070nOO 2
*
**
#
is a number that identifies the disk drive (e.g., 0 for the root disk, 1 for
the next disk installed, etc.). Replace
#
with any unique number, and
use the same number in both the /dev/dsk and /dev/rdsk entries (e.g.,
/dev /dsk/1s0 and /dev /rdsk/1s0). Record the numbers on the Chapter 6,
"Mass Storage" tab.
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the
address was set to 2, and so on.
6-74 Adding Mass Storage Devices