HP 98568A Installation Instruction page 255

HP 7911/7912/7914 Disk/Tape Drives
Table 6-9.
Separate Tape Controller
Connected to Built-in HP-IB Interface (Select Code 7)
Path*
File
Major
Minor **
Interleave
Device Name
Name Type Number Number Factor
HP 7911/12/14 - Tape /dev/ct/#sO b 0 Ox070nOO
1
HP 7911/12/14 - Tape /dev/rct/#sO c
4
Ox070nOO
1
*
Replace
#
with any unique number, and use the same number in both the
/dev/dsk and /dev/rdsk entries (e.g., /dev/dsk/1s0 and /dev/rdsk/1s0).
Record the numbers on the Chapter 6, "Mass Storage" tab.
**
n is a number that identifies the address (set in step 4 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the address
was set to 2, and so on.
Table 6-10.
Separate Tape Controller
Connected to HP 98624 HP-IB Interface (Select Code 8)
File Major
Minor * *
Interleave
Device Name
Path*
Name Type Number Number Factor
HP 7911/12/14 - Tape
HP 7911/12/14 - Tape
/dev/ct/#sO
b
/dev/rct/#sO c
o
4
Ox080nOO
Ox080nOO
1
1
*
#
is a number that identifies the tape drive. Replace
#
with any unique
number, and use the same number in both the /dev/ct and /dev/rct entries
(e.g., /dev/ct/1s0 and /dev/rct/1s0). Record the numbers on the Chapter 6,
"Mass Storage" tab.
**
n is a number that identifies the address (set in step 5 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the address
was set to 2, and so on.
Adding Mass Storage Devices 6-29