Verification Test; Adding Vmebus Cards - HP 98568A Installation Instruction

HP 98577 A VMEbus Expander
Verification Test
1. With a small, flat-blade screwdriver, loosen the two captive screws on the
cover plate of slot 2 (that is, the second slot from the bottom), and remove
the cover plate.
Note
Do not loosen or remove any screws other than the captive
screws on the slot cover plates. Also, do not change the
position of the small RFI clips on the plates.
2. Turn power on to the Expander (but not to the computer).
3. A red LED located at the rear edge of the card in slot 1 should turn on and
remam on.
4. Turn the computer on. The LED in step 3 should now turn off and remain
off. (If you boot HP-UX and have the VME driver installed, the LED
should come on again).
5. If these two don't happen, try again.
Adding VMEbus Cards
The VMEbus Expander adheres to the specifications established by the
VMEbus International Trade Association (VITA), revision C.l. VMEbus
accessories which do not adhere to the VITA C.l specification are not
guaranteed to operate properly, if at all, in the VMEbus Expander.
Refer to the installation information that came with your VMEbus cards to
properly install them in the VMEbus Expander.
INSTALLATION COMPLETE!
Do You Have Another Expander to Add?
NO
Proceed to Chapter 3, "RAM Cards".
YES Refer to the table of contents for this chapter to find
where your next installation instructions begin.
2-22 Adding Expanders