HP 98568A Installation Instruction page 184

HP 98562-66530 Human (System) Interface Board
If you later want to enable the RS-232C Serial interface, move the
switch back to the
0
position as shown in Figure 5-33.
4. Set the RS-232C Remote Terminal Enable Switch.
SKIP?
The interface is shipped from the factory with the remote
terminal enable switch set to local mode. If you intend to
connect a terminal to the RS-232C interface, and want this
terminal to be the system console, continue with this step.
Otherwise, skip to step 5.
a. Find the group of four switches labeled "HPIBjRS232". The switch
labeled "REM" in this group is the Remote Terminal Enable switch (see
Figure 5-33).
b. Set the "REM" switch as follows:
• If you are connecting a terminal to this interface and want this
terminal to be the system console, set this switch to 1, which is the
opposite of that shown in Figure 5-33.
• If you are connecting a terminal to this interface but do not want this
terminal to be the system console, or if you are connecting any other
device, set this switch to 0 as shown in Figure 5-33.
5. Set the Modem Lines Enable Switch.
a. Find the group of four switches labeled "HPIBjRS232". The switch
labeled "MEN" in this group is the Modem Lines Enable switch (see
Figure 5-33).
b. Set the "MEN" switch as follows:
• If you intend to connect an HP 2601A printer, an HP 2686A
LaserJet
printer, an HP 92205AjC Hayes SmartModem, or a uucp, set this
switch to 1 as shown in Figure 5-33.
• If you intend to connect a terminal or the HP 39800jOlA bar code
reader, set this switch to 0, which is the opposite of that shown in
Figure 5-33.
6. Set the LAN Select Code
5-88 Adding Interface Cards