HP 98568A Installation Instruction page 148

HP 98627 A Color Output Interface
b. Remove the Color Output Interface from its envelope, being careful to
handle the card only by its edges and metal end plate. The card may be
easily damaged by electrostatic discharge (static zap).
c. Place the card on the envelope.
2. Set the Select Code.
SKIP?
If this is the first (or only) HP 98627 A Color Output Interface
you are installing, you can skip to step 3. The Color Output
Interface is preset to use select codes 28 and 29, and need not
be changed.
Possible Conflict: The Multiprogrammer Interface is preset
to select code 29 and will conflict with the default select code
setting of the Color Output Interface. If you have both of these
interfaces, change the select code of the Multiprogrammer
Interface.
a. Find the set of four select code switches by referring to Figure 5-23.
b. The select code switches must be set to an even select code and the next
odd select code must not be used by another interface. Find an even
select code that meets this stipulation.
c. Refer to the manual that came with the interface to set the select code
switches to the value you've chosen.
3. Set Option Switch 1.
SKIP?
If you intend to connect an HP 13279B Color Monitor to this
interface, you can skip to step 4. Option switch 1 is preset for a
combined green and sync signal and need not be changed.
a. Set option switch 1 as follows:
• If connecting an HP 13279B Color Monitor to this interface, set option
switch 1 for combined green and sync signal as shown in Figure 5-23 .
• If connecting some other monitor, set option switch 1 opposite of that
shown in Figure 5-23 if the monitor provides for a separate sync signal;
5-52 Adding Interface Cards