Worksheet Entries; Spooled Printing - HP 98568A Installation Instruction

Worksheet Entries
HP 2686A/D
LaserJet
HP 33440A LaserJet-/l
HP 33447A LaserJet-/lD Printer
You have now installed your HP 2686A/D or 33440A Printer.
The following "Worksheet Entries" contain information needed to use your
printer with the HP-UX operating system. Refer to the entries for the interface
you'll be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you'll be ready to install your next peripheral. If you have
installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Spooled Printing
For spooled printing, use the 2686a spooler model file. For unspooled printing,
insert the following shell commands into / etc/rc:
nohup sleep 2000000000 < /dev/lp2686
&
stty -parenb -ienqak cs8 9600 -cstopb -clocal ixon opost onlcr tab3 <
/dev/lp2686
To configure the interface for raster graphics printing, execute the following
stty command (or equivalent ioctl
(2)
calls). Reissue the sequence above
after printing raster data.
stty -parenb -ienqak cs8 9600 -cstopb -clocal ixon -opost < /dev/lp2686
Device Name
Table 7-12.
HP 2686A/D, 33440A or 33447A
Connected to Series 300 Built-in Interface
Path File Major
Name Type Number
HP 2686A/D and 33440A/ 47 A, select /dev/lp2686 c 1
code 9
Minor
Number
Ox090004
Adding Printers 7-29