Worksheet Entries - HP 98568A Installation Instruction

HP 9144A Tape Drive
Worksheet Entries
You have now installed your HP 9144A Tape Drive.
The following "Worksheet Entries" contain information needed to use your
tape drive with the HP-UX operating system. Refer to the entries for the
interface you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you will be ready to install your next peripheral. If you
have installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Table 6-29.
HP 9144A Tape Drive
Connected to Built-in HP-IB Interface (Select Code 7)
Path File Major Minor Interleave
Device Name Name
...
Type Number Number ... *
Factor
HP 9144A
/dev/ct/#sO
b 0 Ox070nOO
1
HP 9144A
/dev/rct/#sO
c
4
Ox070nOO
1
*
#
is a number that identifies the tape drive. Replace
#
with any unique
number, and use the same number in both the /dev/ct and /dev/rct entries
(e.g., /dev/ct/ls0 and /dev/rct/lsD). Record the numbers on the Chapter 6,
"Mass Storage" tab.
**
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the address
was set to 2, and so on.
Adding Mass Storage Devices 6-91