HP 98568A Installation Instruction page 490

HP 46086A Button Box
Worksheet Entries
You have now installed your HP 46086A Button Box.
The following "Worksheet Entries" contain information needed to use your
button box with the HP-UX operating system.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you'll be ready to install your next peripheral. If you have
installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Note
HP -HIL devices can be added to or removed from the HP -HIL
interface without affecting the HP-UX operating system.
However, if your application requires the use of a particular
device and you remove the device from the link, open the
link to the device, or open the link to add a new device, your
application might not recognize the change and may not work
as expected.
Table 10-13.
HP 46086A Button Box
Worksheet Entries
Path
File Major Minor
*
Power
Device Name Name Type Number Number Req.
HP 46086A /dev/r8042 c 23 OxOOOOOO 53 rnA
HP 46086A /dev/buttons
c 24 OxOOOO20 53 rnA
* The second minor number in the table assumes the button box is the second
device on the HP-HIL interface (address=2). If this is not the case, substitute
the correct position (address) of the button box in place of the 2 in the minor
number (e.g., if the button box is the third device on the interface, the minor
number would be OxOOOO30).
10-48 Adding Miscellaneous Peripherals