HP 98568A Installation Instruction page 231

HP Series 6100 Model 600/A
CD-ROM Drive
• On the back of the CD-ROM drive, find the address dial located in the
lower left corner .
• Using a small fiat-blade screwdriver, rotate the inner arrow of the dial to
point to the desired address.
4. Record the HP-IB address.
Make a note that the address you chose in step 4 of this procedure has been
used and is no longer available on the interface you selected.
5. Connect the Model 600/ A to your computer.
a. Connect one end of an HP-IB cable to the HP-IB connector on the back
of the Model 600/ A. Tighten the thumb screws to secure the connection.
b. Connect the other end of the HP-IB cable to the interface.
Note
If the HP-IB interface already has several cables connected
to it, connect your Model 600/ A cable to one of the devices
connected to the interface.
6. Connect the power cord.
Connect the female end of the power cord to the "AC LINE" socket on the
back of the CD-ROM drive, and connect the other end to your power outlet.
Note
Detailed instructions for making the Model 600/ A a part of the
host can be found in the HP Series 6100 Model 600/ A HP-IB
CD-ROM User's Guide, HP part number C1707-90000.
Adding Mass Storage Devices 6-5