Worksheet Entries - HP 98568A Installation Instruction

HP 35723A HP Touch Bezel
Worksheet Entries
You have now installed your HP 35723A HP Touch Bezel.
The following "Worksheet Entries" contain information needed to use your HP
Touch bezel with the HP-UX operating system.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you'll be ready to install your next peripheral. If you have
installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Note
HP-HIL devices can be added to or removed from the HP-HIL
interface without affecting the HP-UX operating system.
However, if you are running an application which requires the
use of a particular device and you remove the device from the
link, open the link to the device, or open the link to add a new
device, your application might not recognize the change and
may not work as expected.
Table 10-1.
HP 35723A HP Touch Bezel
Worksheet Entries
Path File Major Minor
*
Power
Device Name Name
Type Number Number Req.
HP 35723A /dev/r8042 c 23 OxOOOOOO 133 rnA
HP 35723A /dev/touch c 24 OxOOOO20
133 rnA
* The second minor number in the table assumes the digitizer is the second device
on the HP-HIL interface (address=2). If this is not the case, substitute the
correct position (address) of the digitizer in place of the 2 in the minor number
(e.g., if the digitizer is the third device on the interface, the minor number would
be OxOOOO30).
Adding Miscellaneous Peripherals 10-9