HP 98568A Installation Instruction page 505

HP 92916A Bar Code Reader
Installation Procedure
Note
Connecting and disconnecting
HP-HIL
devices while some
language/ operating systems or application programs are
running may lead to unpredictable results. When possible,
connect all needed
HP-HIL
devices to your computer before
booting a language/operating system or running an application
program.
1. Find the
HP-HIL
cable that came with the bar code reader.
2. Find the end of the cable that is marked with one black dot.
3. Find the
HP-HIL
connector on the bar code reader that is marked with one
dot.
4. Plug the "one-dot" end of the cable into the "one-dot" connector on the bar
code reader.
5. Connect the other, "two-dot" end of the cable into the
HP-HIL
connector on
your computer (marked "KYBD" or "KEYBOARD"), or to the "two-dot"
connector of the last
HP-HIL
device you installed (e.g. keyboard).
NOTE!
Connect your
HP
46020/21 keyboard to the
HP-HIL
interface
before connecting the bar code reader. The keyboard must be
"upstream" from the bar code reader in the chain of
HP-HIL
devices.
6. Connect the wand to the bar code reader.
7. Set the Configuration Switches:
a. Set the code selection switches, 1 through 3, according to your
application:
Adding Miscellaneous Peripherals 10-63