Dodge ZB 2005 Service Manual page 1339

VERIFICATION TESTS
Verification Tests —
POWERTRAIN VERIFICATION TEST VER - 5
1. Inspect the vehicle to ensure that all engine components are properly installed and
connected. Reassemble and reconnect components as necessary.
2. If any existing diagnostic trouble codes have not been repaired, go to the appropriate
Symptom List and follow path specified.
3. Connect the DRBIII to the data link connector.
4. Ensure the fuel tank has at least a quarter tank of fuel. Turn off all accessories.
5. If the PCM was not replaced skip steps 6 through 8 and continue the verification.
6. If the PCM was replaced, the correct VIN and mileage must be programmed or a DTC will
set in the ABS and Air Bag modules.
7. In addition, start the vehicle 20 times after the module is replaced. After 20 starts, the new
PCM is in the proper in-field mode and will kill the fuel if it doesn't receive the VTA Status
J1850 message from the BCM.
8. For ABS and Air Bag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS
and Air Bag modules.
9. If the Catalyst was replaced, with the DRBIII
Catalyst Replaced and press enter.
10. If a Comprehensive Component DTC was repaired, perform steps 11 and 13. If a Major
OBDII Monitor DTC was repaired skip step 11 and continue the verification.
11. After the ignition has been off for at least 10 seconds, restart the vehicle and run 2 minutes.
12. With the DRBIII , monitor the appropriate pre-test enabling conditions until all conditions
have been met. Once the conditions have been met, switch screen to the appropriate OBDII
monitor, (Audible beeps when the monitor is running).
13. If the conditions cannot be duplicated, erase all DTCs with the DRBIII .
14. If another DTC has set, return to the Symptom List and follow the path specified for that
DTC.
Did the OBDII monitor run successfully and has the Good Trip Counter changed to one or
more?
Yes → Repair is complete.
→ Check for any related Technical Service Bulletins and/or refer to the
No
appropriate Symptoms list (Diagnostic Procedure).
Continued
go to the miscellaneous Menu Option
218
APPLICABILITY
All