Dodge ZB 2005 Service Manual page 1475

AIRBAG
PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND —
TEST
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Gauge Cluster C1 connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Measure the resistance of the PAB Indicator Driver circuit between the Gauge
Cluster and ground.
Is the resistance below 10K ohms?
Yes → Go To 4
→ Repair or replace the Passenger Airbag Off Indicator in accor-
No
4 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACEDTO TAKE THE PROPER PRECAUTIONS
COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND PER-
SONAL INJURY OR DEATH.
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool Adaptor to the ACM connector.
Measure the resistance of the PAB Indicator Driver circuit between the Gauge
Cluster connector and ground.
Is the resistance below 10K ohms?
Yes → Repair the Passenger Off Indicator Driver circuit shorted to
→ Test Complete.
No
5 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
Connect the appropriate Load Tool ACM Adapter to the Airbag Control Module
connector(s).
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
Connect a jumper wire to the PAB Indicator Driver circuit between the Airbag Load
Tool ACM Adaptor and ground.
Wait 10 seconds and observe the PAB Off Indicator.
Is the Off Indicator ON?
Yes →
→ Go To 6
No
ACTION
dance with the Service Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
ground.
Perform AIRBAG VERIFICATION TEST - VER 1.
WARNING: MAKE SURE THE BATTERY IS DISCONNECTED,
THEN WAIT TWO MINUTES BEFORE PROCEEDING. Replace
the Airbag Control Module in accordance with Service Informa-
tion.
Perform AIRBAG VERIFICATION TEST - VER 1.
94
Continued
APPLICABILITY
All
All
All