Dodge ZB 2005 Service Manual page 962

ZB
GLASS-OUTSIDE REARVIEW MIRROR (Continued)
NOTE: Pressure must be applied equally over the
center portion of the mirror to engage the mirror
glass holder's attaching fingers to the correspond-
ing fingers on the housing assembly. One or more
clicks may be heard when finger engagement takes
place.
(4) Verify retention of the mirror glass holder
assembly by gently pulling outward on the mirror
glass holder.
TRUNK PAN
REMOVAL
(1) Remove the rear fascia. (Refer to 13 - FRAME
& BUMPERS/BUMPERS/REAR
REMOVAL)
(2) Remove the quarter panels. (Refer to 23 -
BODY/EXTERIOR/REAR
REMOVAL)
(3) Remove the sport hoop mounting brackets.
(Refer to 23 - BODY/INTERIOR/SPORT HOOP -
REMOVAL)
(4) Remove the convertible top assembly. (Refer to
23 - BODY/CONVERTIBLE TOP/FOLDING TOP
ASSEMBLY - REMOVAL)
(5) Remove the three nuts securing the trunk pan
to the front support bracket. (Fig. 24)
(6) Remove the two bolts to either side of the fuel
pump cover. (Fig. 25)
(7) Remove the two bolts from inside the trunk
area.
(8) Remove the two outside bolts above the wheel-
house. (Fig. 26)
(9) Remove the bracket bolts from the inside of the
wheelhouse.
(10) Remove the trunk pan.
INSTALLATION
(1) Replace any necessary trunk pan seals. (Refer
to 23 - BODY/BODY STRUCTURE/SEALER LOCA-
TIONS - SPECIFICATIONS)
(2) Install the trunk pan.
(3) Install the bracket bolts inside the wheelhouse
and tighten to 6 N·m (55 in. lbs.).
(4) Install the two outside bolts and washers above
the wheelhouse and tighten to 6 N·m (55 in. lbs.).
FASCIA
QUARTER PANEL
-
-
Fig. 24 TRUNK PAN FRONT BRACKET
1 - TRUNK PAN ASSEMBLY
2 - TRUNK PAN SEAL
3 - FRAME ASSEMBLY
4 - TRUNK PAN TO FRAME FRONT ATTACHING BRACKET
(5) Install the two bolts and washers inside the
trunk area and tighten to 28 N·m (21 ft. lbs.).
(6) Install the two bolts and washers to either side
of the fuel pump cover and tighten to 9 N·m (80 in.
lbs.).
(7) Install the three nuts securing the trunk pan
to the front support bracket and tighten to 12 N·m (9
ft. lbs.).
(8) Install the convertible top assembly. (Refer to
23 - BODY/CONVERTIBLE TOP/FOLDING TOP
ASSEMBLY - INSTALLATION)
(9) Install the sport hoop mounting brackets.
(Refer to 23 - BODY/INTERIOR/SPORT HOOP -
INSTALLATION)
(10) Install the quarter panels. (Refer to 23 -
BODY/EXTERIOR/REAR
INSTALLATION)
(11) Install the rear fascia. (Refer to 13 - FRAME
& BUMPERS/BUMPERS/REAR FASCIA - INSTAL-
LATION)
EXTERIOR 23 - 51
QUARTER PANEL -