Dodge ZB 2005 Service Manual page 1207

DRIVEABILITY - GAS
P0201-INJECTOR #1 CONTROL CIRCUIT —
P0205-INJECTOR #5 CONTROL CIRCUIT
When Monitored: With battery voltage greater than 10.4 volts, the auto shutdown relay
energized, injector pulse width less than 10ms, and engine speed less than 3000 rpm.
Set Condition: This trouble code takes .64 to 10.0 seconds to set when no inductive kick
is sensed .18ms after injector turn off, and with no other injectors on.
P0206-INJECTOR #6 CONTROL CIRCUIT
When Monitored: With battery voltage greater than 10.4 volts, the auto shutdown relay
energized, injector pulse width less than 10ms, and engine speed less than 3000 rpm.
Set Condition: This trouble code takes .64 to 10.0 seconds to set when no inductive kick
is sensed .18ms after injector turn off, and with no other injectors on.
P0207-INJECTOR #7 CONTROL CIRCUIT
When Monitored: With battery voltage greater than 10.4 volts, the auto shutdown relay
energized, injector pulse width less than 10ms, and engine speed less than 3000 rpm.
Set Condition: This trouble code takes .64 to 10.0 seconds to set when no inductive kick
is sensed .18ms after injector turn off, and with no other injectors on.
P0208-INJECTOR #8 CONTROL CIRCUIT
When Monitored: With battery voltage greater than 10.4 volts, the auto shutdown relay
energized, injector pulse width less than 10ms, and engine speed less than 3000 rpm.
Set Condition: This trouble code takes .64 to 10.0 seconds to set when no inductive kick
is sensed .18ms after injector turn off, and with no other injectors on.
P0209-INJECTOR #9 CONTROL CIRCUIT
When Monitored: With battery voltage greater than 10.4 volts, the auto shutdown relay
energized, injector pulse width less than 10ms, and engine speed less than 3000 rpm.
Set Condition: This trouble code takes .64 to 10.0 seconds to set when no inductive kick
is sensed .18ms after injector turn off, and with no other injectors on.
P0210-INJECTOR #10 CONTROL CIRCUIT
When Monitored: With battery voltage greater than 10.4 volts, the auto shutdown relay
energized, injector pulse width less than 10ms, and engine speed less than 3000 rpm.
Set Condition: This trouble code takes .64 to 10.0 seconds to set when no inductive kick
is sensed .18ms after injector turn off, and with no other injectors on.
GOOD TRIP EQUAL TO ZERO
(K342) ASD RELAY OUTPUT CIRCUIT
FUEL INJECTOR
FUEL INJECTOR DRIVER CIRCUIT OPEN
POSSIBLE CAUSES
86
Continued