Dodge ZB 2005 Service Manual page 888

ZB
EXTENSION HOUSING SEAL (Continued)
Fig. 115 SEAL REMOVAL
1 - REMOVER
2 - SEAL
CAUTION: Replace drive shaft joint straps when-
ever they are removed. The straps slightly deform
when torqued in place. Reuse of the straps may
result in reduced clamp load on the universal joint
cap.
(3) Check transmission fluid level.
(4) Install belly pan.
INPUT SHAFT
REMOVAL
NOTE: If input shaft is damaged behind the seal,
the transmission must
inspected.
(1) Remove transmission from the vehicle.
(2) Measure output shaft end play and record
number.
(3) Remove clutch slave cylinder from transmission
adapter plate.
(4) Remove front adapter plate bolts (Fig. 116).
(5) Pry front cover adapter loose.
(6) Hold input shaft while removing adapter (Fig.
117).
(7) Remove seal from transmission adapter.
be disassembled and
MANUAL TRANSMISSION - T56 21 - 37
Fig. 116 ADAPTER BOLTS
1 - ADAPTER BOLTS
2 - INPUT SHAFT
Fig. 117 ADAPTER
1 - TRANSMISSION CASE
2 - ADAPTER PLATE
(8) Clean and inspect all sealing surfaces for wear
or damage.