Dodge ZB 2005 Service Manual page 976

ZB
GLOVE BOX (Continued)
(1) Disconnect the check straps to the door.
(2) Remove three screws retaining glove box
assembly and remove from panel.
INSTALLATION
(1) Place glove box into panel opening and install
the three screws retaining glove box assembly.
(2) Connect the check straps.
(3) Close glove box and verify operation. Adjust as
necessary.
GLOVE BOX LATCH STRIKER
REMOVAL
WARNING: Follow all Warnings for airbag compo-
nent service (Refer
STRAINTS - WARNING).
(1) Open glove box.
(2) Remove two glove box latch striker retaining
screws and remove latch striker from panel.
INSTALLATION
WARNING: Follow all Warnings for airbag compo-
nent service (Refer
STRAINTS - WARNING).
(1) Place glove box latch striker into position and
install the two retaining screws.
(2) Close glove box and verify operation. Adjust as
necessary.
INSTRUMENT PANEL RIGHT
LOWER TRIM
REMOVAL
WARNING: Follow all Warnings for airbag compo-
nent service (Refer
STRAINTS - WARNING).
(1) Open deck lid.
(2) Remove four bolts to battery compartment
cover and remove cover.
(3) Disconnect and isolate the battery negative
cable.
(4) Wait two minutes for the airbag system reserve
capacitor to discharge before beginning any airbag
system or instrument panel component service.
(5) Remove the cluster bezel. (Refer to 23 - BODY/
INSTRUMENT PANEL/CLUSTER
REMOVAL)
to 8 - ELECTRICAL/RE-
to 8 - ELECTRICAL/RE-
to 8 - ELECTRICAL/RE-
BEZEL
(6) Remove the glove box. (Refer to 23 - BODY/IN-
STRUMENT PANEL/GLOVE BOX - REMOVAL)
(7) Remove the glove box striker. (Refer to 23 -
BODY/INSTRUMENT PANEL/GLOVE BOX LATCH
STRIKER - REMOVAL)
(8) Remove the two screws to the left of the glove
box opening.
(9) Remove three screws to instrument panel right
lower trim and remove from panel.
(10) Disconnect the glove box light electrical con-
nector.
INSTALLATION
WARNING: Follow all Warnings for airbag compo-
nent service (Refer
STRAINTS - WARNING).
(1) Install five screws to instrument panel right
lower trim.
(2) Install three screws retaining glove box assem-
bly.
(3) Connect one electrical connector on cluster
bezel, place in position over retaining slots and
firmly snap into place.
(4) Connect one electrical connector to instrument
panel center bezel and install six screws to center
bezel.
(5) Connect one electrical connector to center con-
sole, place into position and install eight screws to
console.
(6) Install floor console bezel and parking brake
body.
(7) Install shifter shaft with knob and body.
(8) Install six allen screws to shifter bezel.
(9) Connect the battery negative cable.
(10) Place battery access cover into place and
install four bolts.
(11) Close deck lid.
(12) Verify vehicle and system operation.
INSTRUMENT PANEL CENTER
BEZEL
REMOVAL
WARNING: Follow all Warnings for airbag compo-
nent service (Refer
STRAINTS - WARNING).
(1) Open decklid.
(2) Remove four bolts to battery compartment
cover and remove cover.
-
(3) Disconnect and isolate the battery negative
cable.
INSTRUMENT PANEL 23 - 65
to 8 - ELECTRICAL/RE-
to 8 - ELECTRICAL/RE-