Driver Window Hall Effect Failure - Dodge ZB 2005 Service Manual

Symptom:

DRIVER WINDOW HALL EFFECT FAILURE

When Monitored and Set Condition:
DRIVER WINDOW HALL EFFECT FAILURE
When Monitored: Whenever the driver window is operating.
Set Condition: The hall effect sensor in the window motor sends an alternating signal
(open/closed) to the BCM whenever the motor is running. When there is no hall effect
signal to the BCM from the window motor, this code will set.
DTC PRESENT
IOD - B(+) WIRE OPEN
HALL EFFECT SWITCH OPEN
DRIVER WINDOW HALL SIGNAL WIRE OPEN
DRIVER WINDOW MOTOR OPEN
DRIVER WINDOW HALL SIGNAL WIRE SHORT TO GROUND
DRIVER WINDOW UP DRIVER OPEN
WINDOW HALL EFFECT GROUND OPEN
DRIVER WINDOW DOWN DRIVER OPEN
BODY CONTROL MODULE - WINDOW DRIVER OPEN
BODY CONTROL MODULE - DRIVER WINDOW HALL EFFECT OPEN
TEST
1 NOTE: If there are any other Driver Power Window DTC's present, diagnose
those DTC's before proceeding with this code.
Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Driver Window Motor several times.
With the DRBIII , read DTCs.
Does the DRBIII display DRIVER WINDOW HALL EFFECT FAILURE?
Yes → Go To 2
→ The condition that caused the code to set is not present at this
No
POSSIBLE CAUSES
ACTION
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
339
POWER WINDOWS
APPLICABILITY
All