Dodge ZB 2005 Service Manual page 1620

BCM - ACCESSORY RELAY CONTROL CIRCUIT OPEN —
TEST
3 Turn the Ignition off.
Remove the Accessory Relay from the PDC.
Disconnect the Body Control Module C4 connector.
Measure the resistance of the Accessory Relay Control circuit between the BCM C4
connector and the Relay connector.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the Accessory Relay Control circuit for an open.
No
4 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
IGNITION, POWER, ACCESSORY
239
Continued
APPLICABILITY
All
All