Dodge ZB 2005 Service Manual page 856

ZB
MANUAL TRANSMISSION - T56 (Continued)
(10) Disconnect reverse lamp switch and skip shift
solenoid main connector at left side frame rail. Dis-
connect reverse lamp switch connector on the right
side of the transmission.
(11) Remove upper transmission to bell housing
bolts.
(12) Raise engine/transmission.
(13) Remove bottom transmission bolts.
(14) Raise engine up slightly to aid in transmis-
sion removal/installation.
(15) Slide transmission back so that the input
shaft clears bell housing. Then lower transmission.
DISASSEMBLY
(1) Remove shift cover bolts and remove shift
cover.
(2) Remove roll pin from rear offset lever (Fig. 5).
Fig. 5 OFFSET LEVER ROLL PIN
1 - HAMMER
2 - PIN PUNCH
3 - OFFSET LEVER
(3) Remove offset lever from shaft (Fig. 6).
(4) Remove two tail housing nuts from top of the
transmission tail housing (Fig. 7).
MANUAL TRANSMISSION - T56 21 - 5
Fig. 6 OFFSET LEVER
1 - OFFSET LEVER
2 - TAIL HOUSING
Fig. 7 TAIL HOUSING NUTS
1 - VENT
2 - NUTS
3 - TAIL HOUSING