Dodge ZB 2005 Service Manual page 848

ZB
HOSE - RETURN - FAN TO PUMP (Continued)
(7) Fill power steering pump reservoir to correct
fluid level. (Refer to 19 - STEERING/PUMP/FLUID -
STANDARD PROCEDURE)
(8) Perform Power Steering Pump Initial Opera-
tion procedure. (Refer to 19 - STEERING/PUMP -
STANDARD PROCEDURE).
(9) Check for leaks at all hose connections.
HOSE - RETURN - GEAR TO
COOLER
REMOVAL
NOTE: Review all Warnings and Cautions. (Refer to
19 - STEERING - WARNING).
1 - RADIATOR MOUNTING FASTENERS
2 - COOLING MODULE
3 - FAN MOUNTING FASTENERS
4 - U - NUT
CAUTION: Cap all open ends of power steering
hoses, power steering pump fittings and steering
gear ports when disconnected. This will prevent the
entry of foreign material into the components dur-
ing servicing.
(1) Disconnect negative (-) cable from battery and
isolate cable.
(2) Remove air cleaner housing. (Refer to 9 -
ENGINE/AIR
HOUSING - REMOVAL)
(3) Siphon power steering fluid from fluid reser-
voir.
(4) Unthread power steering return hose tube nut
from power steering gear port (Fig. 7). Pull tube out
of gear port and drain excess power steering fluid
from line.
(5) Remove two radiator mounting screws (Fig. 8).
Fig. 8 Radiator And Fan
5 - LOWER RADIATOR HOSE
6 - FAN ELECTRICAL CONNECTOR
7 - UPPER RADIATOR HOSE
8 - DRAINCOCK
PUMP 19 - 33
INTAKE SYSTEM/AIR CLEANER