Dodge ZB 2005 Service Manual page 1721

POWER WINDOWS
DRIVER WINDOW HALL EFFECT FAILURE —
TEST
2 Turn the ignition on.
With the DRBIII , actuate the Driver Window Down and Up..
Does the Driver Window go Up and Down?
Yes → Go To 3
→ Go To 9
No
3 Turn the ignition off.
Disconnect the Window Motor connector.
Measure the resistance between ground and the Ground circuit.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the Window Hall Effect Ground circuit for an open.
No
4 Disconnect the Window Motor connector.
Turn the ignition on.
Measure the voltage between the IOD - B(+) circuit and ground.
Is the voltage above 10.0 volts?
Yes → Go To 5
→ Repair the IOD - B(+) circuit for an open from the BCM.
No
5 Disconnect the Window Motor connector.
Turn the ignition on.
With the DRBIII in Inputs/Outputs, read the DRV WINDOW HALL state.
While observing the DRBIII , momentarily connect and disconnect a jumper wire
between the Driver Window Hall Signal circuit and the Window Hall Effect Return
circuit.
Does the DRBIII display toggle between OPEN and CLOSED?
Yes → Replace the Window Motor.
→ Go To 6
No
6 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C3 harness connector.
Measure the resistance of the Driver Window Hall Signal circuit between the Motor
connector and the BCM C3 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 7
→ Repair the Driver Window Hall Signal circuit for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
340
APPLICABILITY
All
All
All
All
All