Dodge ZB 2005 Service Manual page 1041

24 - 12 CONTROLS
A/C COMPRESSOR CLUTCH (Continued)
(7) Tap the clutch plate lightly with a plastic mal-
let to release it from the splines on the compressor
shaft. Remove the clutch plate and shim(s) from the
compressor shaft (Fig. 4).
NOTE: Use care not to lose any of the shim(s).
CAUTION: Do not pry between the clutch plate unit
and the pulley to remove the clutch plate from the
compressor shaft as this may damage the clutch
plate.
Fig. 4 Clutch Plate and Shim(s)
1 - A/C COMPRESSOR SHAFT
2 - CLUTCH PLATE
3 - SHIM
(8) Using snap ring pliers (Special Tool C-4574 or
equivalent), remove the external snap ring that
secures the pulley to the front cover of the compres-
sor, then slide the pulley off of the compressor (Fig.
5).
(9) Remove the screw that secures the clutch coil
pigtail wire connector bracket and ground clip to the
top of the compressor housing.
(10) Using snap ring pliers (Special Tool C-4574 or
equivalent), remove the external snap ring that
secures the clutch coil to the front cover of the com-
pressor housing, then slide the clutch coil off of the
compressor (Fig. 6).
Fig. 5 Clutch Pulley Snap Ring
1 - SNAP RING
2 - SNAP RING PLIERS
3 - CLUTCH PULLEY AND BEARING
Fig. 6 Clutch Coil Snap Ring
1 - SNAP RING PLIERS
2 - CLUTCH FIELD COIL
3 - A/C COMPRESSOR
4 - SNAP RING
ZB