Dodge ZB 2005 Service Manual page 902

ZB
SENSOR - TPM (Continued)
(9) Pull upward on the tire (Fig. 17). Reach inside
the tire and remove the pressure sensor/transmitter.
Fig. 17 Pressure Transmitter Removal (Typical)
1 - TIRE
2 - WHEEL
3 - PRESSURE SENSOR/TRANSMITTER
INSTALLATION
NOTE: When installing the tire pressure sensor/
transmitter, replace the sealing grommet at the
valve stem base before installing the pressure
transmitter in the wheel. Also, be sure the surface
of the wheel that the grommet seals against is
clean and not damaged.
(1) Install the tire pressure sensor/transmitter on
the wheel (Fig. 18).
Fig. 18 Sensor Mounting To Wheel
1 - TIRE PRESSURE SENSOR
2 - WHEEL
3 - NUT
(2) Install the special sensor mounting nut. When
tightening the tire pressure sensor/transmitter nut,
hold the sensor so it does not rotate. Once tightened,
the gap between the sensor and the wheel must be
even on both sides as shown (Fig. 19). If the sensor/
transmitter rotates (clocks), damage to the sensor/
transmitter can occur when mounting the tire.
Tighten the nut to a torque of 4 N·m (35 in. lbs.).
Fig. 19 Sensor Correctly Mounted In Wheel
1 - WHEEL
2 - GAP SHOULD BE EVEN AT BOTH THESE POINTS
CAUTION: When mounting the upper bead of the
zero pressure tire, the proper procedure must be
used. Not using the proper procedure will result in
damage to the wheel and tire.
(3) Mount the upper bead of the tire on the wheel.
(4) Install the original or an OEM replacement
valve stem cap on the valve stem.
(5) Using a soap solution, check that no air leak is
present where the valve stem mounts to the wheel.
(6) Balance the tire and wheel assembly using the
correct procedure for wheel flange mount and
stick-on wheel weights. For balancing information
and wheel weight positioning, (Refer to 22 - TIRES/
WHEELS - STANDARD PROCEDURE).
(7) Install the tire wheel assembly on the vehicle.
(Refer to 22 - TIRES/WHEELS - INSTALLATION)
(8) Program the identification code for the new tire
pressure sensor/transmitter into the TPM module.
(Refer to 22 - TIRES/WHEELS/TIRE PRESSURE
MONITORING/MODULE - STANDARD PROCE-
DURE)
TIRES/WHEELS 22 - 11