Dodge ZB 2005 Service Manual page 1508

Symptom:
PASSENGER SQUIB 2 CIRCUIT SHORT
When Monitored and Set Condition:
PASSENGER SQUIB 2 CIRCUIT SHORT
When Monitored: When the ignition is on, the ACM monitors the resistance of the
Passenger Squib 2 circuits.
Set Condition: The ACM has detected low resistance in the Passenger Squib 2 circuits.
PASSENGER AIRBAG CIRCUIT SHORT
PASSENGER SQUIB 1 LINE 1 SHORT TO LINE 2
STORED CODE OR INTERMITTENT CONDITION
ACM, PASSENGER SQUIB 2 CIRCUIT SHORT
ACTIVE CODE PRESENT
TEST
1 NOTE: Ensure that the battery is fully charged.
Turn the ignition on.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Passenger Airbag connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active DTCs.
Does the DRB show PASSENGER SQUIB 2 CIRCUIT SHORT?
Yes → Go To 3
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 4
→ Replace Passenger Airbag in accordance with the Service Infor-
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
127
AIRBAG
APPLICABILITY
All
All