Dodge ZB 2005 Service Manual page 1102

ZB
EVAP/PURGE SOLENOID (Continued)
INSTALLATION
(1) Make sure that you have the proper orientation
of the EVAP/Purge solenoid (Fig. 6).
Fig. 6 SOLENOID ORIENTATION
(2) Install EVAP/Purge solenoid to the mounting
bracket (Fig. 5), make sure that the rubber grommet
in the solenoid fully when installed.
(3) Connect the vacuum lines.
(4) Connect the electrical connection
(5) Connect the negative battery cable.
FUEL FILLER CAP
DESCRIPTION
If the filler cap (Fig. 7) needs replacement, only
use a similar unit.
Fig. 7 Pressure Vacuum Filler Cap
1 - FUEL FILLER TUBE CAP
2 - GASKET
EVAPORATIVE EMISSIONS 25 - 13
OPERATION
The fuel filler tube cap seals the fuel tank when
threaded onto the filler neck. For safety, the cap con-
tains pressure-vacuum relief valves. A malfunction in
the system or damage to the fuel lines could cause
excessive fuel tank pressure. The relief valves pre-
vent possible excessive pressure or vacuum build-up
in the fuel tank.
Removing the cap breaks the seal, relieving fuel
tank pressure.
LEAK DETECTION PUMP
REMOVAL
NOTE: The trunk panel (Fig. 8) will have to be cut to
remove the LDP pump.
(1) Disconnect the negative battery cable.
(2) Put access panel in place and scribe the outline
of the panel. Mark the hole for the rivet that hold the
panel in place.
Fig. 8 TRUNK PANEL