Dodge ZB 2005 Service Manual page 1679

POWER DOOR LOCKS/RKE
DRIVER CYLINDER UNLOCK SWITCH SHORT TO GROUND —
TEST
3 Disconnect the Driver Cylinder Unlock Switch connector.
Disconnect the Body Control Module C3 connector.
Measure the resistance between Driver Cylinder Unlock Switch Mux circuit and
ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the Driver Cylinder Unlock Switch Mux circuit for a short
→ Go To 4
No
4 If there are no possible causes remaining, view repair.
Repair
ACTION
to ground.
Perform BODY VERIFICATION TEST - VER 1.
Disconnect the BCM harness connector(s). Check connectors -
Clean/repair as necessary. If okay, replace the Body Control
Module.
Perform BODY VERIFICATION TEST - VER 1.
298
Continued
APPLICABILITY
All
All