Dodge ZB 2005 Service Manual page 1285

DRIVEABILITY - GAS
P1493-AMBIENT/BATTERY TEMPERATURE SENSOR VOLTAGE TOO
LOW —
Continued
TEST
4 Measure the resistance between the (K25) Battery Temp Signal circuit and the
(K900) Sensor ground circuit at the Battery Temp Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the short between the (K900) Sensor ground circuit and
→ Go To 5
No
5 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
Repair
ACTION
the (K25) Batt Temp Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Replace and program the Powertrain Control Module per Service
Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
164
APPLICABILITY
All
All