Dodge ZB 2005 Service Manual page 984

ZB
BULKHEAD QUARTER TRIM PANEL (Continued)
(17) Pull back panel up and route the seat belt
through the panel.
(18) Remove the trim panel.
(19) Disconnect the speaker electrical connectors.
(20) Remove the nuts and remove the convertible
top latch assembly.
(21) Remove the four bolts in the front of the sup-
port panel.
(22) Remove the two nuts in the rear of the sup-
port panel and remove.
INSTALLATION
(1) Install the quarter trim support panel and
install the nuts.
(2) Tighten the nuts to 6 N·m (50 in. lbs.).
(3) Install the four front bolts and tighten to 6
N·m (50 in. lbs.).
(4) Install the convertible top latch and install the
nuts.
(5) Tighten the nuts to 10 N·m (85 in. lbs.).
(6) Install the trim panel.
(7) Route the seat belts through the panel.
(8) Install the two screws at the drivers door.
(9) Install the sill plate.
(10) Install the screw at the rear of the console.
(11) Install the sport hoop and install the bolts.
(12) Tighten the bolts to 28 N·m (21 ft. lbs.).
(13) Install the sport hoop fastener cover.
(14) Install the lower seat belt anchor.
(15) Install the two screws at the passenger door.
1 - BULKHEAD QUARTER TRIM PANEL
2 - SPORT HOOP
3 - PLASTIC SNAP IN NUT
Fig. 3 BULKHEAD QUARTER TRIM PANEL REMOVAL
Fig. 2 BULKHEAD QUARTER TRIM SUPPORT
1 - BULKHEAD QUARTER TRIM SUPPORT PANEL
2 - SPORT HOOP ATTACHING BELT
(16) Install the sill plate.
(17) Install the screw at the rear of the console.
(18) Install the sport hoop and install the bolts.
(19) Tighten the bolts to 28 N·m (21 ft. lbs.).
(20) Install the sport hoop fastener cover.
(21) Install the lower seat belt anchor.
4 - BULKHEAD QUARTER TRIM SUPPORT PANEL
5 - SPRING NUT
6 - CENTER CONSOLE
INTERIOR 23 - 73
PANEL