Key In Ignition And Driver's Door Open Chime Not Operating; Properly - Dodge ZB 2005 Service Manual

Symptom:
*KEY IN IGNITION AND DRIVER'S DOOR OPEN CHIME NOT
OPERATING PROPERLY
BODY CONTROL MODULE DTC'S
DRB CHIME ACTUATOR
DRIVER DOOR AJAR STATUS
IGNITION SWITCH
BODY CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , read the current Body Control Module DTC's.
Does the DRBIII display any Lighting or Ignition switch related DTC's?
Yes → Refer to symptom list for related symptom(s).
→ Go To 2
No
2 NOTE: If the complaint is that the chime is on with the driver door open and
key removed, refer to the Chime section in general information and use the
DRBIII under BCM I/O's to verify other inputs are operating properly
before continuing with this test.
With the DRBIII , actuate the CHIME. (BCM actuator)
Does chime sound a warning?
Yes → Go To 3
→ Refer to symptom Chime Inoperative in the Chime category.
No
3 Open the driver door.
With the DRB, in Input/Outputs, read the DR DOOR AJAR SW state.
Does the DRB display DR DOOR AJAR SW: CLOSED ?
Yes → Go To 4
→ Refer to symptom list for problems related to Door Ajar.
No
4 With the DRBIII in BCM Inputs/Outputs, read the Ign Status while inserting the
key in and out of the ignition switch.
Does the DRBIII Ign Status display change?
Yes → Replace and program the Body Control Module in accordance
→ Check the Ignition Lock Cylinder for damage. If OK replace the
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
Ignition Switch.
Perform BODY VERIFICATION TEST - VER 1.
145
CHIME
APPLICABILITY
All
All
All
All