Driver Window Switch Short To Ground - Dodge ZB 2005 Service Manual

POWER WINDOWS
Symptom:

DRIVER WINDOW SWITCH SHORT TO GROUND

When Monitored and Set Condition:
DRIVER WINDOW SWITCH SHORT TO GROUND
When Monitored: Whenever the ignition is in the RUN or ACCESSORY position.
Set Condition: When the BCM senses that the voltage on the Driver Window Switch Mux
circuit is less than 0.69 volts for longer than 10 seconds.
DTC PRESENT
SWITCH SHORTED
DRIVER WINDOW SWITCH MUX WIRE SHORT TO GROUND
BODY CONTROL MODULE - DRIVER WINDOW SWITCH MUX CIRCUIT SHORTED
TEST
1 Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Driver Window Motor several times.
With the DRBIII , read DTCs.
Does the DRBIII display DRIVER WINDOW SWITCH SHORTED TO GROUND?
Yes → Go To 2
→ The condition that caused the code to set is not present at this
No
2 Disconnect the Window Switch connector.
Turn the ignition on.
Measure the voltage between Driver Switch Mux circuit and ground.
Is the voltage approximately 5.0 volts?
Yes → Replace the Window Switch.
→ Go To 3
No
3 Turn the ignition off.
Disconnect the Window Switch connector.
Disconnect the BCM C3 harness connector.
Measure the resistance between ground and the Driver Switch Mux circuit.
Is the resistance below 1000.0 ohms?
Yes → Repair the Driver Window Switch Mux circuit for a short to
→ Replace the Body Control Module.
No
POSSIBLE CAUSES
ACTION
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
344
APPLICABILITY
All
All
All