Decklid Release Output Short To Ground - Dodge ZB 2005 Service Manual

Symptom:

DECKLID RELEASE OUTPUT SHORT TO GROUND

When Monitored and Set Condition:
DECKLID RELEASE OUTPUT SHORT TO GROUND
When Monitored: Whenever the BCM is awake.
Set Condition: When the BCM turns on the Decklid Release Driver circuit and detects a
voltage of less than 0.5 volts for over 125 milliseconds, this code will set.
DTC PRESENT
DECKLID RELEASE SOLENOID
DECKLID RELEASE DRIVER WIRE SHORT TO GROUND
BODY CONTROL MODULE - DECKLID RELEASE DRIVER SHORTED
TEST
1 Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Decklid Release several times.
With the DRBIII , read DTCs.
Does the DRBIII display DECKLID RELEASE OUTPUT SHORT TO GROUND?
Yes → Go To 2
→ The condition that caused the code to set is not present at this
No
2 Disconnect the Decklid Release Solenoid.
Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Decklid Release several times.
With the DRBIII , read DTCs.
Does the DRBIII display DECKLID RELEASE OUTPUT SHORT TO GROUND?
Yes → Go To 3
→ Replace the Decklid Release Solenoid.
No
POSSIBLE CAUSES
ACTION
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
293
APPLICABILITY
All
All