Dodge ZB 2005 Service Manual page 1476

PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND —
TEST
6 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
Connect the appropriate Load Tool ACM Adapter to the Airbag Control Module
connector
Measure the resistance of the PAB Indicator Driver circuit between the ACM Adapter
and the Gauge Cluster connector.
Is the resistance below 5.0 ohms?
Yes → Go To 7
→ Repair the open Passenger Airbag Indicator Driver circuit.
No
7 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Gauge Cluster C1 connector.
NOTE: Check connectors - Clean and repair as necessary.
Measure the voltage of the IOD Fused B(+) circuit between the Gauge Cluster C1
connector and ground.
Is the voltage above 9.0 volts?
Yes → Replace the Gauge Pack in accordance with the Service Informa-
→ Repair the open IOD Fused B(+) circuit.
No
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
tion.
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
95
AIRBAG
Continued
APPLICABILITY
All
All