Dodge ZB 2005 Service Manual page 1765

TIRE PRESSURE MONITORING
TPM MODULE INITIALIZED - BCM —
TEST
7 Turn the ignition off.
Disconnect the TPM Module harness connector.
Turn the ignition on.
Measure the voltage of the Low Tire Pressure Signal circuit in the TPM Module
connector.
Is there any voltage present?
Yes → Replace and program the TPM Module in accordance with the
→ Replace and program the BCM Module in accordance with the
No
8 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Service Information.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
Service Information.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
Continued
384
APPLICABILITY
All
All