Dodge ZB 2005 Service Manual page 993

23 - 82 SEATS
SEAT
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 82
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 82
SEAT ADJUSTERS
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 83
SEAT BACK
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 84
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 84
SEAT BACK COVER
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 84
SEAT
REMOVAL
(1) Open deck lid.
(2) Remove four bolts to battery compartment
cover and remove cover.
(3) Disconnect and isolate the battery negative
cable.
(4) Move seat as needed to access seat attaching
front bolts and rear nuts (Fig. 1).
(5) Disconnect electrical connector (Fig. 2).
(6) Remove seat from vehicle.
1 - BUCKET SEAT
SEATS
TABLE OF CONTENTS
page
INSTALLATION
SEAT BACK RECLINER
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85
INSTALLATION
SEAT CUSHION ASSEMBLY
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86
INSTALLATION
SEAT CUSHION COVER
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87
INSTALLATION
INSTALLATION
(1) Place seat assembly in vehicle.
(2) Connect electrical connector (Fig. 2).
(3) Start front seat attaching bolts (Fig. 1).
NOTE: The front BOLTS must be torqued to the
specified torque prior to the rear NUTS being
secured.
(4) Tighten front seat front bolts to 40 N·m (30 ft.
lbs.) torque.
(5) Tighten front seat rear nuts to 40 N·m (30 ft.
lbs.) torque.
(6) Connect the battery negative cable.
Fig. 1 BUCKET SEAT
2 - FLOOR PAN
. . . . . . . . . . . . . . . . . . . . . . . . . 85
. . . . . . . . . . . . . . . . . . . . . . . . . 86
. . . . . . . . . . . . . . . . . . . . . . . . . 87
. . . . . . . . . . . . . . . . . . . . . . . . . 87
ZB
page