Dodge ZB 2005 Service Manual page 1638

BCM - RUN/START HARDWIRE INPUT MISMATCH —
TEST
3 Turn the ignition off.
Disconnect the BCM C2 harness connector.
Disconnect the Ignition Switch harness connector.
Measure the resistance of the Ignition Switch Output (Run-Start) circuit between the
BCM C2 connector and the Ignition Switch connector.
Is the resistance above 5.0 ohms?
Yes → Repair the Fused Ignition Switch Output (Run-Start) circuit for
→ Replace and program the Body Control Module in accordance
No
ACTION
an open. If the fuse is open make sure to check for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
IGNITION, POWER, ACCESSORY
257
Continued
APPLICABILITY
All