Door Held Open Alarm; Anti-Passback; High Security Swipe Timer; Lock/Unlock Swipe Timer - Mircom TX3 Series Installation And Operation Manual

The door held open warning timer is programmable from 10 to 900 seconds. The
default is 30 seconds
3.4.4

Door Held Open Alarm

The door held open alarm timer starts when the door held open warning timer
expires and the door remains open. If the door is still open when this timer
expires, a 'door held open alarm' is issued to the PC and the common alarm status
becomes active. The door held open alarm timer is programmable from 10 to 900
seconds. The default is 60 seconds.
3.4.5

Anti-passback

The anti-passback timer prevents the use of the same card by more than one
person at an access point. The anti-passback timer starts when a valid card is
swiped at an access point. During the anti-passback period, the same card cannot
be used at that access point until the anti-passback timer expires. The
anti-passback timer is programmable from 0 to 900 seconds. The default is 300
seconds.
3.4.6

High Security Swipe Timer

If an access card with the high security privilege is swiped four times in
succession, the mode of the access point toggles between high security on and
high security off. The four successive swipes must be performed before the high
security swipe timer expires. The default is 10 seconds.
3.4.7

Lock/Unlock Swipe Timer

If an access card with the lock/unlock privilege is swiped twice in succession, the
access point toggles between locked and unlocked mode. The two successive
swipes must be performed before the expiry of the lock/unlock swipe timer. The
default is 10 seconds.
3.4.8

Pin Timeout

If a card is swiped during the PIN required schedule, the card holder must enter
the card's PIN before the timer expires in order to gain access. The default is 20
seconds.
The PIN required feature requires a wireless device with a keypad.
TX3 Aperio Door Controller System Installation and Operation Manual
v. 1.6
LT-1160 Copyright 2019
Configuration
77