Setting The Timer Options For An Access Point; Advanced Options - Mircom TX3 Series Installation And Operation Manual

3.4.9

Setting the Timer Options for an Access Point

To set the timer options for an access point
1.
2.
3.
4.
Continue with your configuration settings. After you have completed all of your
configuration settings, connect to your TX3 system and send the job (see section
3.13, Sending Your Configuration, on page 98).
3.5

Advanced Options

The following advanced options can be set for each Access Point. These options
are found under the Advanced tab for the access point.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
TX3 Aperio Door Controller System Installation and Operation Manual
78
LT-1160 Copyright 2019
Find the access point in the job tree.
If you do not see the access point in your job tree, expand the Aperio Door
Controller panel entry, and then expand the panel's Access Point
entry.
Click on the access point.
Select the Timers tab.
Set the timers for the access point.
Detailed information these timers can be found in sections 3.4.1 to 3.4.8.
High security
PC decision required
Deduct usage count
First person in
Facility code mode
Inhibit ID
Timed Anti-passback
Report Not Initialized
Report request to exit
Report unknown format
Report door not open
Auto relock
RTE bypass DC
Disable forced entry alarm
Ignore card facility code
Configuration
v. 1.6