Mircom TX3 Series Installation And Operation Manual page 40

Note:
Once you have created the installation database for your site, you can start
pairing wireless devices to Aperio hubs. Each device can be paired to only one
hub, but each hub can have up to eight devices paired to it.
To pair a wireless device with a hub
1.
2.
3.
4.
Notes:
TX3 Aperio Door Controller System Installation and Operation Manual
40
LT-1160 Copyright 2019
The Encryption Key file should be treated with the same care as the
Master Key in a traditional door security system. Someone with
access to the Encryption Key file can gain unauthorized access to
any door in the system. Once the installation database for your site
has been created, the Encryption Key file should be erased from the
hard drive. A copy of the Encryption Key file should be stored in a
secure location.
Start the Aperio Programming Application.
Select your installation, and then click Open.
Enter the password for your installation, and then click OK.
In the communication hub selection window, select the hub(s) that you
want to pair your device(s) to, and then click Show details.
• The values in the in the Communication Hub column are the
last four digits of the Aperio hub's MAC address. The MAC
address for each hub is printed on a label attached to the side of
the Aperio hub.
• If your hub is not listed in the communication hub selection
window, click Rescan.
Installation and Setup
v. 1.6