Table of Contents
Advertisement
The Network Firmware Upgrade procedure can update more than one panel at
the same time. In order to use the Network Firmware Upgrade, all of the panels
must already have firmware that supports this feature installed on them.
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of types of firmware upgrade. LT-995 can be found on
the TX3 Configurator Software installation CD, USB flash drive, or on the
Mircom website.
2.11.1
Firmware Version Control
The firmware version number is accessible from the configurator software and
changes whenever there is a major, minor or revision update.
The following convention is used whenever there is a major, minor or revision
change:
Initial release. Version 1.00.0
Major change. Version 2.00.0
Minor change. Version 2.01.0
Revision changes. Version 2.01.1
2.12
Beginning Configuration
The Aperio Door Controller is now configurable using the following
connections.
•
•
•
•
For a complete description of the configuration and on how to establish a
connection to the Aperio Door Controller using a USB, ethernet, COM port or
modem connection, see the following documentation:
•
•
Verify the following:
•
TX3 Aperio Door Controller System Installation and Operation Manual
v. 1.6
LT-1160
Copyright 2019
USB connection
Ethernet connection
COM port connection
Modem connection
LT-995 Configuration and Administration Guide
TX3 Configurator Quick Start LT-973
Ensure that the controller and all connected devices and components are
fully operational.
Installation and Setup
63
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers