Deleting An Access Point; Access Point Schedule Options - Mircom TX3 Series Installation And Operation Manual

4.
5.
Continue with your configuration settings. After you have completed all of your
configuration settings, connect to your TX3 system and send the job (see section
3.13, Sending Your Configuration, on page 98).
3.2.2

Deleting an Access Point

Wireless devices that have been unpaired from an Aperio Door Controller panel
should have their access points deleted from the job.
To delete an access point
1.
2.
3.
Continue with your configuration settings. After you have completed all of your
configuration settings, connect to your TX3 system and send the job (see section
3.13, Sending Your Configuration, on page 98).
3.3

Access Point Schedule Options

Access points can be configured to go into certain modes according to a
schedule. These modes are:
•
•
These modes are described in sections 3.3.1to 3.3.2. Section 3.3.3 explains how
to enable a mode by selecting a schedule for it.
When a schedule becomes valid, the access point begins to operate under the
mode. For example, if you select a schedule called "Office Hours" for the
Auto-unlock mode, the access point automatically unlocks during the days and
times set in the "Office Hours" schedule. Once the schedule ends, the access
point goes into locked mode.
TX3 Aperio Door Controller System Installation and Operation Manual
74
LT-1160 Copyright 2019
Select the model of your wireless device from the Lock Type list.
Enter a label for the access point in the Access point label text box.
Find the access point you want to delete in the job tree.
If you do not see the access point in your job tree, expand the Aperio Door
Controller panel entry, and then expand the panel's Access Point
entry.
Right-click on the access point you want to delete, and then select
Delete Access Point.
Click OK.
Auto-unlock
PIN required
Configuration
v. 1.6