Configuring The Aperio Hubs; Figure 19 The Hub Should Be On The Same Side Of The Wall As The Devices, And Facing - Mircom TX3 Series Installation And Operation Manual

•
•
•
2.6.2

Configuring the Aperio Hubs

Before installing the Aperio hubs, you must configure the hubs to communicate
with the Aperio Door Controller. This section contains instructions on how to
perform the following tasks.
1.
2.
3.
TX3 Aperio Door Controller System Installation and Operation Manual
32
LT-1160 Copyright 2019
The Aperio hubs and wireless devices should be installed at least 1 foot
away from mirrors and large metallic surfaces (for example, cable
ladders).
The Aperio hubs and wireless devices should be kept at least 13 feet away
from WiFi/WLAN routers, radio transmitters, and other sources of
electromagnetic interference (for example, microwave ovens, electric
motors, and other high power electrical equipment).
It is recommended that you verify the radio link quality using the Aperio
Programming Application (APA).
Figure 19. The hub should be on the same side of the wall as the
devices, and facing them
Setting the Aperio hub address
Connecting the TX3-CX-A8 to the Aperio hubs
Powering the Aperio hubs
Installation and Setup
v. 1.6