Figure 25 Communication Hub Paired Successfully; Figure 26 No Locks Or Sensors Were Paired - Mircom TX3 Series Installation And Operation Manual

8.
TX3 Aperio Door Controller System Installation and Operation Manual
42
LT-1160 Copyright 2019
The Aperio Programming Application pairs the device with the hub. If the
pairing is successful, the following window appears.
Figure 25. Communication hub paired successfully
The values shown in the window are the last six digits of the device's
MAC address.
If the pairing is unsuccessful, the following window appears.
Figure 26. No locks or sensors were paired
To try pairing the device again, click Close and then repeat steps 5 to 7
until the pairing is successful.
Click Close, and then select the device that you just paired in the Aperio
Programming Application Window.
Installation and Setup
v. 1.6