Action - Mircom TX3 Series Installation And Operation Manual

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To specify where the event happens, you must select one of the inputs or access
points on your Aperio Door Controller panel configuration. What you can select
from depends on the type of event you chose:
•
•
3.8.2

Action

The Action section is where you define what to do when an event happens. To
define an action, you need to specify:
•
•
•
TX3 Aperio Door Controller System Installation and Operation Manual
88
LT-1160 Copyright 2019
Door held open alarm restored (at an access point)
Door held open warning (at an access point)
Door held open warning restored (at an access point)
Door not open (at an access point)
Request to Exit. A request to exit has been made.
Input is active. Select a panel input from 1 to 8.
Input is normal. The general purpose input becomes inactive.
Unlock mode is on (at an access point)
Unlock mode is off (at an access point)
High security is on (at an access point)
High security is off (at an access point)
Tamper detected (at an access point)
Tamper restored (at an access point)
Battery is normal (at an access point)
Battery is low (at an access point)
Battery is flat (at an access point)
Lockset is offline. The lockset is not communicating with its Aperio hub.
Lockset is online. The lockset has resumed communicating with its
Aperio hub.
If you selected an event that is related to an access point, then the
At access point list appears. This list shows all of the access points
configured on your panel.
If you selected an event that is related to an input (that is, Input is active),
the Input label list appears. This list shows all of the inputs
configured on your panel.
what action to take
where the action will happen
for how long to perform the action.
Configuration
v. 1.6