3.4.3
Extended unlock timer
The timer starts when the door unlocks. When the door unlock timer expires the
door locks. The timer resets when the main door sense is programmed to be
inactive. The extended unlock timer is programmable from 10 to 300 seconds.
The default is 15 seconds.
3.4.4
Anti-pass-back timer
The anti-pass-back timer starts when access is granted. In this mode the user is
restricted access to another access point until the anti-pass-back timer expires.
When the timer expires the user has access. The anti-pass-back timer is
programmable from 0 to 900 seconds. The default is 300 seconds.
3.4.5
Door held open warning timer
The door held open warning timer starts when access is granted. When the door
unlock timer expires and the door does not close during this interval a 'door held
open' warning is issued to the PC and the common trouble status becomes active.
If the door closes during this interval, the timer resets and no warning report is
sent to the PC.
The door held open warning timer is programmable from 10 to 900 seconds. The
default is 30 seconds
3.4.6
Door held open alarm timer
The door held open alarm timer starts when the door held open warning timer
expires and the door remains not closed. When this timer expires and the door is
still open, a 'door held open alarm' is issued to the PC and the common alarm
status becomes active. The door held open alarm timer is programmable from 10
to 900 seconds. The default is 60 seconds
3.5
Schedules
Schedules let you set up a timetable to establish when certain actions are
permitted to occur, such as door access. These schedules are designated and
listed by name in the configurator software, and are available for selection
wherever it is necessary to invoke access permission.
There is a maximum of 64 schedules than programmed into the system. Each
schedule is consist of four periods and each period consist of
•
•
Version 1.00.3
TX3-CX Card Access System Installation and Operation Manual
Copyright 2009
Start time and end time in hours: minutes format
Week days and week end and holiday selection
Configurable Features
45 (56)
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers