Figure 28 Security Mode Status And Details For A Device-Hub Pair - Mircom TX3 Series Installation And Operation Manual

Note:
2.7.3.1 Determining the Security Modes for a Device-Hub Pair
Pairing a wireless device with an Aperio hub does not ensure secure
communication between them. Secure communication is only established when
both device and hub are communicating in Customer Mode. After you have
paired a device with a hub, use the Aperio Programming Application to
determine what security mode the device and hub are using.
To determine the security mode of a device-hub pair
1.
2.
3.
4.
5.
Security Mode
Status Icons
Security Mode
Conflict Details
TX3 Aperio Door Controller System Installation and Operation Manual
46
LT-1160 Copyright 2019
Leaving an installation in Manufacturer Mode compromises the
security of your installation because anyone with the Aperio
Programming Application and a Tritech TriBEE USB dongle could
gain full access to your installation. It is highly recommended that
you change your security mode to Customer Mode.
Start the Aperio Programming Application.
Select your installation, and then click Open.
Enter the password for your installation, and then click OK.
In the communication hub selection window, select the hubs in your
installation, and then click Show details.
Select a device-hub pair.
The icons next to the UHF link icons indicate the security mode of the
device-hub pair (see Figure 28). If there is a conflict in security mode
settings between the device and the hub, information about the conflict is
given in the details pane.
Figure 28. Security mode status and details for a device-hub pair
Installation and Setup
v. 1.6