Figure 29 Configuration Summary - Mircom TX3 Series Installation And Operation Manual

To set a wireless device to Customer Mode
1.
2.
3.
4.
5.
6.
7.
TX3 Aperio Door Controller System Installation and Operation Manual
48
LT-1160 Copyright 2019
to all of the other devices. See section 2.7.6, Saving and Applying a
Configuration, on page 56 for information on saving a
configuration.
Select the device in the Aperio Programming Application.
Right-click on the wireless device, and then select either Configure or
Lock/sensor > Configure.
Click Next until you reach the Security Mode Setting page.
Click Change.
Select Switch to Customer mode in device, and then click OK.
Click Next until you reach the Device Update page.
This page summarizes all the configuration changes you have made. Your
page should look similar to the following figure (that is, it should show
that the Security Mode will be set to Customer Mode).
Figure 29. Configuration summary
Click Next.
Installation and Setup
v. 1.6