Editing Card Details - Mircom TX3 Series Installation And Operation Manual

To add a card
1.
2.
3.
The new card is added to the Card Configuration window. At this point, you
should configure the options for this card by editing the card details (see section

3.10.2, Editing Card Details).

Continue with your configuration settings. After you have completed all of your
configuration settings, connect to your TX3 system and send the job (see section
3.13, Sending Your Configuration, on page 98).
3.10.2 Editing Card Details
The Card Details window lets you set more options for each card. It is here where
you can, for example, set an activation date for a card and give a card certain
privileges.
TX3 Aperio Door Controller System Installation and Operation Manual
v. 1.6
LT-1160 Copyright 2019
Select Add Cards from the Menu Bar or right click in the Card
Configuration window and select Add Cards.
Enter the following information:
Total number of cards to add. Specify the number of cards to add.
Name. Provide a name for the card holder.
Card number. Enter the card number.
Access level. Select up to three access levels for the card.
Facility Code. Provide the facility code for the card.
Click OK.
Configuration
93